Our 15 Recommendations:
15 Best Car Stereo Amplifiers Reviews:
- 750 watt maximum power full-range amplifier
- Amplifier Class: AB
- No. of channel: 2/1 Channel
- Max. Output Power: 750W x 2
- Power - 1100 Max x 1 @ 2 Ohms, 550 Max x 1 @ 4 Ohms
- Class A/B Topology - Class ‘A’ amplifiers have enormous amount of current flowing through its output transistors with no audio signal. Class ‘B’ amplifiers have no current flowing through its outputs with no audio signal
- Mosfet Power Supply - A MOSFET is an electrical switch that allows the flow of electrical current. It controls the output voltage & current precisely by removing the output current sensing loss & eliminating all secondary feedback circuitry
- Low & High Level Inputs - A low level (RCA) input is measured in voltages. A high level (+/- wire) input is measured in wattages. Both essentially carry signal from your receiver to your amplifier to your speakers
- Variable Low-Pass Crossover - Subwoofers reproduce sound based on a number of different low-range frequencies. You can set exact sound specifications for the bass frequency reproduction
- 1500W Maximum Power Full-Range Amplifier
- Optimized 150-watt RMS output and a max power output of 1500 watts, you can give your music a huge boost in power that will have you and your passengers partying while on the road
- This slim amplifier fits perfectly into any trunk so you can easily connect it to your stereo system
- Power - 100 Watts Max X 4 @2-Ohms, 50 Watts Max X 4 @4-Ohms
- Class A/B Topology - Class ‘A’ Amplifiers Have Enormous Amount Of Current Flowing Through Its Output Transistors With No Audio Signal. Class ‘B’ Amplifiers Have No Current Flowing Through Its Outputs With No Audio Signal
- Full Range - With A Full Range Amplifier You Not Only Have The Option To Run Your Speakers, But Also Your Subwoofers
- Variable Gain Control - The Gain Control Is Not For Adjusting Volume. It Simply Adjusts The Amount Of Signal That Is Coming From Your Receiver And Going To Your Amplifier
- Blaupunkt AMP1604 4-Channel, Full-Range Amplifier Max. Output Power: 1600W
- Power - 800 Watts Max x 2 @2-Ohms 400 Watts Max x 2 @4-Ohms 1600 Watts Max x 1 Bridged @4 Ohms
- Full Range - With a Full Range amplifier you not only have the option to run your speakers but also your subwoofers
- Class A/B Topology - Class ‘A’ amplifiers have enormous amount of current flowing through its output transistors with no audio signal Class ‘B’ amplifiers have no current flowing through its outputs with no audio signal
- Mosfet Power Supply - A MOSFET is an electrical switch that allows the flow of electrical current It controls the output voltage and current precisely by removing the output current sensing loss & eliminating all secondary feedback circuitry
- Variable Gain Control - The gain control is not for adjusting volume It simply adjusts the amount of signal that is coming from your receiver and going to your amplifier
- 1000 watt 4 channel PowerDriveX series class AB car amplifier
- Low noise pre amplifier
- Maximum low voltage signal from the source unit comes into the amplifier circuit with minimal distortion
- Low level RCA inputs and outputs
- Highest sound quality connection
- CX-Series Amplifiers are the perfect combination of big power, bigger flexibility and true reliability!
- A variable 12dB crossover, KickEQ 6dB variable bass boost and a 24dB subsonic filter on mono amps gives you the control you want - to craft the sound you love.
- Mono KICKER CX Amplifiers are now stable down to one Ohm, giving you the freedom to put even more subs in your system!
- CX-Series amps include vertical and horizontal mounting hardware, so you can show off your install style!
- These powerful amps work with as little as nine volts of power from your battery, and as much as 40 volts (400 watts) of speaker-level input signal.
- Class D MOSFET Monoblock Power Amplifier
- Peak Power at 1 Ohm: 1,600 Watts | RMS Power at 1 Ohm: 1,200 Watts
- Frequency Response: 20Hz - 250Hz, On-board Bass EQ Switch with +6 or +12dB boost at 45Hz
- Featuring 4-Way Protection Circuitry and 4 Gauge Power & Ground Input Terminals for Maximum Current Flow. Damping Factor - 150<
- Stable at 1 ohm | Remote Subwoofer Level Control Included
- Generator low frequency test tones
- Great for showing off subwoofers
- 98hz down to and earth shaking 10hz
- English (Publication Language)
- Includes: Amplifier. Bass Remote. Birth sheet with tested power. Owner’s manual. Mounting Screws. Warranty.
- Rockville dB55 4000 Watt/2000 Watt RMS 5 Channel Amplifier. CEA Compliant Power Ratings (Rated at less than 1 % distortion) (Use these CEA ratings when matching and comparing with other CEA compliant brands such as Kicker, Rockford Fosgate, etc). 2 Ohm: 120 Watts x 4 + 500 Watts x 1 <1% THD+N. 4 Ohm: 80 Watts x 4 + 300 Watts x 1 <1% THD+N.
- RMS Power Ratings: (Use these RMS ratings when comparing with great brands such as Hifonics, Earthquake, Soundstream, etc). 2 Ohm 240 Watts x 4 + 1000 Watts x 1. 4 Ohm: 160 Watts x 4 + 600 Watts x 1. Peak: (The amount of power the amplifier can produce for a split second at the loudest part of a song. 2 Ohm 480 Watts x 4 + 2000 Watts x 1. 4 Ohm: 320 Watts x 4 + 1200 Watts x 1.
- High-Speed MOSFET Power Supply. Rugged switching MOSFETs for Class D in CH5. Under Voltage Protection at 10V. Over Voltage Protection at 16V. Optical Coupler Class “AB” +“D” Technology. Studio-Grade Bipolar Output Stage Transistors. Fully Adjustable 12dB / Octave Crossover with Differential Circuitry. Low Pass Filter: (CH1-CH4)40Hz –4KHz /(CH5)50Hz –250Hz. High Pass Filter: 15Hz – 4KHz. Subsonic Filter: 15Hz - 55Hz.
- Full IC-Controlled Protection Circuitry. Remote Dashboard Subwoofer Control. Fully Adjustable 12dB Bass Equalizer. Mute and Delay Soft Start System. 8 Volt Preamp Circuitry. Status Mode LED Indicator. Minimum THD at Rated Power: < 0.05%. S / N Ratio: >90dB. Frequency Response: 15-35KHz. Damping Factor: >[email protected] 100Hz. 40 Amp x3. Dimensions: (W x H x L) 9'' x 2.4' x 18.6".
- 1000 Watts Max Power
- Automatic signal sensing and Turn-On
- Variable high pass filter
- Adjustable bass boost
- Rockville RXD-M3 4000 Watt/2000w RMS Mono Class D 1 Ohm Car Stereo Amplifier With Optical Coupler Technology.
- CEA Compliant Power Ratings: 1 Ohm: 1000 Watts x 1 Channel <1% THD+N. 2 Ohm: 750 Watts x 1 Channel <1% THD+N. 4 Ohm: 550 Watts x 1 Channel <1% THD+N).
- RMS Power Ratings: 1 Ohm: 2000 Watts x 1 Channel. 2 Ohm: 1500 Watts x 1 Channel. 4 Ohm: 1100 Watts x 1 Channel.
- Peak: 1 Ohm: 4000 Watts x 1 Channel. 2 Ohm: 3000 Watts x 1 Channel. 4 Ohm: 2200 Watts x 1 Channel.
- High-Speed MOSFET Power Supply. Optical Coupler Class "D" Technology. Studio-Grade Bipolar Output Stage Transistors.
- High-precision metal casing, streamlined protection structure, improved work-discharge thermal conductivity and high-quality heat dissipation performance, enabling the power amplifier to work stably for a long time and at high power.
- High-density pure copper three-color large circulation, smaller size, higher power, make more reasonable adjustments to the power demand of the power amplifier, to ensure safe, efficient, continuous and stable operation of the power amplifier.
- With short circuit, overload, overheat protection.
- Equipped with efficient heat dissipation all aluminum pits.
Last update on 2023-01-12 / Affiliate links / Images from Amazon Product Advertising API