Our Favorites:
Best Car Audio Powered Subwoofer Reviews:
- 30W 8-Inch Amplified Subwoofer.Power source type:Corded Electric.Speaker size:8 inches
- Made with the highest technical quality to ensure maximum reliability and durability
- MAX power handling 300 watts (300 Watts Peak) and an RMS power handling of 120 watts (300 Watts Peak)
- Features variable bass boost, adjustable input sensitivity, and a low-pass filter
- powered polypropylene subwoofer with built-in amplifier that matches the woofer performance at 150W RMS or 450W Peak.
- 12" (305mm) woofer
- 35 - 120Hz frequency response
- Slipstream port eliminates port noise and provides distortion-free bass at high output levels
- Polypropylene Woofer Cone
- 1300 W Max Power (350 W Nominal) Pre-loaded 12" Injection Molded Polypropylene (IMPP) Composite Cone Construction Subwoofer
- Built-in 300 W Max (150 W RMS) Class D amplifier
- Ported enclosure design for powerful, deep and accurate bass response
- Variable Bass Boost (0 to +12 dB, 20Hz to 130Hz)
- Rockville RW10CA 800 Watt 10" Slim Car Subwoofer.
- 800 Watts Peak / 200 Watts RMS. PWM MOSFET Power Supply.
- Low Level RCA Input. High Level Inputs with Auto Turn-On Technology.
- Adjustable Input Sensitivity. Soft Delayed Remote Turn-On.
- Thermal Protection Circuit, Short Protection Circuit.
- Amplifier Power Output: 120 Watts RMS.Power source type:Corded Electric.Speaker size:8 inches
- 8" High performance subwoofer in a carpeted, vented enclosure
- High Level and RCA inputs for easy connection in any system set up
- External Bass Control is included for convenient control of volume from front of vehicle
- Rockville SS8P 8" 400w Slim Under-Seat Active Powered Car/Truck Subwoofer Sub.
- Enclosure is made out of cast aluminum which stays cool at all times. Peak Power Handling: 400 Watts.
- RMS Power Handling: 100 Watts. Heavy Duty Mounting Feet. PWM MOSFET Power Supply. Low Level RCA Input. High Level Inputs with Auto Turn-On Technology. Adjustable Input Sensitivity. Soft Delayed Remote Turn-On. Thermal Protection Circuit, Short Protection Circuit. Overload Protection Circuit. Green Power/Red Protect LED. Phase Switch: 0° or 180°.
- Low Pass Filter: 50Hz - 150Hz. Bass Boost: 0 - 12dB @ 45Hz. Built in Subsonic Filter @ 20Hz. THD: < 0.4%. Subwoofer Level Remote Control. Fuse Rating: Single 15A.
- Specifications: Peak Power 400 Watts. RMS Power: 100 Watts. Impedance: 4 Ohm. Dimensions (L x W X H): 11.4" x 8.3" x 2.8" Inches. Frequency Response: 20Hz - 150Hz. Signal to Noise Ratio: >90dB. Sensitivity: 90dB @ 1w / 1m. Input sensitivity, Low level: 300mV. Input sensitivity, High level: 1.0V
- 200-watt max, 120-watt RMS power output
- Designed to add extra bass to a car audio system that’s short on space
- built-in matched amp eliminates need to buy a separate amp, saves space, and easier to install
- Frequency response: 50 Hz to 150 Hz
- 8 in. preinstalled woofer
- Power Handling: Peak: 550 watts RMS: 200 watts
- PWM MOSFET Power Supply/Thermal Protection Circuit Remote Subwoofer Control Included RCA and High-Level Inputs
- Delayed Soft Remote Turn On Adjustable Input Sensitivity
- Variable Bass Boost: 0 - +12 dB Variable Low-pass Filter: 85 - 150 Hz
- Constant Subsonic Filter: @ 35Hz Selectable Phase : 0 or 180 degrees
- Rockville RBV10. 1A Single 10” 500 Watts Active Subwoofer Enclosure, Size: 10”, Peak Power: 500 Watts, RMS Power: 300 Watts, Nominal Impedance: Single 4-Ohm, 1. 5” Voice Coil, Inverted Carbon Graphite Molded Dust Cap, Kevlar Reinforced Pulp Cone, Double Lami
- Frequency Response: 35Hz - 200Hz, Sensitivity: 88dB, Anti-Vibration Braced MDF Cabinet, Angled Back Fits Perfectly Against Rear Seats, Computer Tuned Bass Reflex Port, Blue/Black Aviation Grade Tweed Carpet with Embroidered Rockville Logo.
- Class AB Amplifier, High Speed MOSFET Power Supply, High Level Speaker Inputs, Low Level RCA Inputs, Built-In Low Pass Crossover (30Hz - 160Hz).
- Accepts up to 8 Gauge Wire, 100mV - 5V Input Voltage, Power (Blue) & Diagnostic (Red) LED Indicators, 20A Fuse, Dimensions in inches: Length 15. 75" x height: 12. 99" x top width 10. 63" x bottom width: 14. 17", Weight: 22. 59 lbs.
- Built-in Amplifier - With a MOSFET power supply you get improved switching speeds, better performance with less power from the driver, lower gate-to-drain feedback capacitance, lower thermal impedance for higher switching frequencies
- Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes above the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s)
- High Level Inputs - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the LOPRO10 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs
- Low-Level Inputs - Line level inputs (RCA inputs / low-level inputs) use RCA interconnect cables to link the LOPRO10 with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers
- Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it
- 8-Inch Subwoofer And 120W Amplifier, Housed Together In A Cast Aluminum Enclosure
- The Compact Size Measures Just 13.5” L X 9” W X 3” D So It Can Be Installed Under Or Behind A Seat In A Truck, In A Sedan’S Trunk Or In An Suv’S Hatch
- 32Hz-150Hz Frequency Response, Power Rating: 120W Rms. Rca (0.1-4V) / Speaker Input (1.5-30V/Auto Sensing)
- Rca And Auto-Sensing Speaker Level Inputs Are Located On The Side Panel, Along With Controls For Phase, Gain, Lp Crossover And Remote Sub Level
- The Punch P300-10T is a universal "all in one" self-contained subwoofer enclosure with built-in amplifier for dropping Bass in any factory or aftermarket system
- The 10" high output subwoofer is impedance optimized for the built in 300-watt class-D amplifier in a slim design enclosure - Dimensions: 13.3" x 21.7" x 7.9" x 4.8"
- Featuring an adjustable 12db/Octave low pass crossover, built-in adjustable bass boost EQ, and built-in 0°/180° phase switch
- The enclosure can be connected via speaker level inputs for connection to factory systems, or traditional line level inputs for aftermarket systems
- Famous Rockford Fosgate build quality with a full 1-year warranty when purchased from an authorized Rockford Fosgate reseller
- Space Saver - The combination of amplifier and subwoofer all into one, makes this ideal for spatially challenged vehicles. With a slim design, there are a few installation options. Embrace the Bass.
- Built-in Amplifier - A built-in 800 Max watt amplifier powers the subwoofer
- Pulse Width Modulated - This design controls the output voltage and current precisely by not only removing the output current sensing loss, but also eliminating all secondary feedback circuitry. It increases efficiency, is lighter, smaller reliable
- Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s)
- High Level Input - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the BAB8 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs
- Fully functional and easy to debug
- 68 mm Slim fuselage, installed under the seat, the effect is better
- 10 inch woofer speaker
- Design of high temperature resistant coil
- Black paint stainless steel mesh, no rust, no deformation
- Rockville WHEEL OF BASS 8" 500w Slim Under-Seat or Trunk Mounted Powered Car Subwoofer.
- Enclosure is very shallow at only 3.15” tall so it can fit anywhere. You can fit it under seat but it also sounds great and takes up little space in your trunk.
- Enclosure is made out of solid cast aluminum. Peak Power Handling: 500 Watts. RMS Power Handling: 125 Watts. Heavy Duty Mounting Feet. PWM MOSFET Power Supply.
- Low Level RCA Input. High Level Inputs with Auto Turn-On Technology. Adjustable Input Sensitivity. Soft Delayed Remote Turn-On. Thermal Protection Circuit, Short Protection Circuit
- Overload Protection Circuit. Green Power/Red Protect LED. Phase Switch: 0° or 180°. Low Pass Filter: 50Hz - 180Hz. Bass Boost: 0 - 12dB @ 45Hz. Built in Subsonic Filter @ 20Hz
Last update on 2023-02-09 / Affiliate links / Images from Amazon Product Advertising API